EVK-JODY-W2 - User guide
UBX-19027118 - R06
Contents
Page 11 of 25
C1 - Public
Figure 5: Resistor modification to enable host connection through an adapter
2.5
Host interface for Bluetooth
JODY-W2 series modules support a high-speed UART interface for Bluetooth communication.
A USB-to-UART bridge (FTDI FT231X) is included on the evaluation board. Follow the procedure
outlined below to connect the board to a host system through USB.
1.
Connect one end of the USB cable to the Bluetooth USB connector on the board.
2.
Connect the other end of the USB cable to the host system.
3.
Check that jumper
J400
is bridged to enable Bluetooth communication over UART through FTDI.
☞
The 4-pin UART interface of the JODY-W2 series modules can be directly accessed through
the pins on the Bluetooth UART connector
J305
of the EVK. For information on how to use the
Bluetooth UART on the evaluation board, see also
These resistors must be connected
in vertical positions.
