EVK-F9P-01 - User guide
UBX-22038408 - R03
Getting started
Page 8 of 28
C1- Public
3.3
Default interface settings
Parameter
Specification
UART Port 1, input
38400 baud, 8 bits, no parity bit, 1 stop bit.
UBX, NMEA and RTCM 3.3 input protocols are enabled by default.
SPARTN input protocol is enabled by default.
UART Port 1, output
38400 baud, 8 bits, no parity bit, 1 stop bit.
NMEA protocol with GGA, GLL, GSA, GSV, RMC, VTG, TXT messages are output
by default.
UBX and RTCM 3.3 protocols are enabled by default, but no output messages are
enabled by default.
UART2, input
38400 baud, 8 bits, no parity bit, 1 stop bit.
UBX protocol is enabled by default
RTCM 3.3 protocol is enabled by default.
SPARTN protocol is enabled by default.
NMEA protocol is disabled by default.
UART2, output
38400 baud, 8 bits, no parity bit, 1 stop bit.
UBX protocol is disabled by default.
RTCM 3.3 protocol is enabled by default but no output messages are enabled by
default.
NMEA protocol is disabled by default.
USB
Default messages activated as in UART1.
Input/output protocols available as in UART1.
I2C
Compatible with the I2C
industry standard, available for communication with an
external host CPU or u-blox cellular modules, operated in slave mode only. Default
messages activated as in UART1. Input/output protocols available as in UART1.
Maximum bit rate 400 kb/s.
SPI
Allow communication to a host CPU, operated in slave mode only. Default
messages activated as in UART1. Input/output protocols available as in UART1.
SPI is not available unless D_SEL pin is set to low.
Table 3: Default configuration
☞
Refer to the ZED-F9P Integration manual [
] for more information.