28/09/2020
AF-11 Quick Start Guide
https://dl.ubnt.com/qsg/AF-11/AF-11_EN.html
9/15
Repeat the instructions in the airFiber Con guration section on the other AF-11 radio.
For details on the airFiber Con guration Interface, refer to the airFiber AF-11FX User Guide,
available at:
Hardware Installation
Install a Ground Wire
1.
2.
3. At the installation site, secure the other end of the ground wire to a grounded mast,
pole, tower, or grounding bar.
WARNING:
Failure to properly ground your airFiber radio will void your
warranty.
Note:
The ground wire should be as short as possible and no longer than one
meter in length.
Mount to the airFiber AF-11G35 Antenna
1. Attach an RF Cable to an RF connector labeled H or V. Then slide the silicone boot over
the RF connector to protect it.
If using MIMO mode, remove the cap over the second RF connector (V or H) and attach
an RF Cable. Then slide the silicone boot over the RF connector to protect it.
2.
3.
4.
Note:
Align the dot on the side of the shroud with the arrowhead on the dish
antenna.
Connecting Data
1.
2.
3. If you are using DC power, connect the other end of the Ethernet cable to your LAN.
Connecting Power
Note:
For SISO mode, use the RF connector (H or V) as determined by your
licensing. Keep the other RF connector covered with the included Metal Cap.
AF-11 Quick Start Guide
