28/09/2020
AF-11 Quick Start Guide
https://dl.ubnt.com/qsg/AF-11/AF-11_EN.html
5/15
Data LED
Power LED
Management Port
Reset Button
Data Port
VDC IN
TX 0, RX 0
RX 1, TX 1
N Connector
On
Ethernet Link Established
Random Flash
Ethernet Activity
Off
No Ethernet Link
On
Ethernet Link Established
Random Flash
Ethernet Activity
Off
No Power
On
Powered On
10/100 Mbps, secured Ethernet port for con guration. In-Band Management is enabled
by default in the airFiber Con guration Interface. When In-Band Management is
disabled, the MGMT port is the only port that can monitor, con gure, and/or update
rmware.
To reset to factory defaults, press and hold the Reset button for more than 10 seconds
while the device is already powered on.
Gigabit PoE port for handling all user traffic and powering the device.
The terminal block can be used to power the AF-11 with +50VDC, 1.2A instead of PoE.
The TX and RX SMA ports for the Chain 0 Low-Band Duplexer or High-Band Duplexer
(SISO and MIMO modes).
The RX and TX SMA ports for the Chain 1 Low-Band Duplexer or High-Band Duplexer
(MIMO mode only). In SISO mode, these unused ports are protected by the duplexer
cap.
AF-11 Quick Start Guide
