10
Chapter 2: Installation
airFiber
®
AF-5X User Guide
Ubiquiti Networks, Inc.
3. Check to see if a link is established. Ensure that the LINK
LED is solidly lit green and the Signal LEDs of the Slave
are displaying signal levels.
4.
Slave
Aim the Slave at the Master to achieve the
strongest signal level on the Master.
Note:
Refer to “Signal LEDs” on page 2 for
details on the signal values.
Note:
Maximum signal strength can best be
achieved by iteratively sweeping through both
azimuth and elevation.
5.
Master
Aim the Master at the Slave to achieve the
strongest signal level on the Slave.
6. Repeat steps 4 and 5 until you achieve an optimal link,
with all four Signal LEDs solidly lit. This ensures the best
possible data rate between the airFiber radios.
7. Lock the alignment on both airFiber antennas by
tightening all the nuts and bolts.
8. Observe the Signal LEDs of each airFiber radio
to ensure that the values remain constant while
tightening the nuts and bolts. If any LED value changes
during the locking process, loosen the nuts and bolts,
finalize the alignment of each airFiber antenna again,
and retighten the nuts and bolts.
Refer to the following chapters of this User Guide for
details on the airFiber Configuration Interface:
• “Main Tab” on page 13
• “Wireless Tab” on page 16
• “Network Tab” on page 19
• “Advanced Tab” on page 21
• “Services Tab” on page 24
• “System Tab” on page 27
• “Tools” on page 30
Installer Compliance Responsibility
Devices must be professionally installed and it is the
professional installer’s responsibility to make sure the
device is operated within local country regulatory
requirements.
The Output Power, Antenna Gain, Cable Loss, and Frequency
fields are provided to the professional installer to assist in
meeting regulatory requirements.
www.4Gon.co.uk [email protected] Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299
