UBI EasyCoder 601 XP – Service Manual Ed. 1
23
Chapter 4 Chassis
The bottom plate is fitted with four easily replaceable rubber feet.
These feet could be removed and the holes used to bolt the printer
to a frame, table or similar. The holes have a diameter of 10 mm
(0.39").
The two keyholes should never be used to bolt the printer to a frame,
or the bottom plate may be bent causing ribbon wrinkling and paper
misalignment. These holes are only used for fixtures during manu-
facture.
The bottom plate is also fitted with four hinges, two for the front
hatch or cutter unit and the other two for the right-hand door. In case
of misalignment, the hinges could be adjusted using a #T10 Torx
key.
The rear plate is attached to the bottom plate using three #T20 Torx
screws and to the centre-line wall by two #T20 Torx screws. There
is also a bracket between the rear plate and the centreline wall. The
rear plate has a number of slots for connectors, switches etc. as
illustrated below.
4.3 Bottom Plate
4.4 Rear Plate
Main Switch
Mains Receptacle
Memory Card Slot
RS 232C Serial Interface ("uart1:")
Centronics Parallel Interface
Provision for one Optional Interface Board
Bar Code Wand Connector
Provision for 1 – 2 Electronic Keys
Upper External Paper Intake
Lower External Paper Intake
