7
�
When lighting your burner, remove all parts from stand to prevent an explosion from gas
build up.
�
If burner does not ignite, turn off the gas and wait 5 minutes before trying to light it again.
If the burner goes out during operation, first turn regulator OFF, then the gas cylinder.
�
Do not allow anyone to conduct activities around your cooker during or following its use,
until burner has gas cooled. The burner is hot during operation and remains hot for a
period of time following its use.
�
Never allow the gas hose to touch any hot surface on the burner stand.
�
Always allow the hot water or oil in the pot to cool completely before moving to avoid the
possibility of severe burns.
�
Be careful when removing food from the cooker for it is hot and could cause burns.
�
Never use glassware, plastic, or ceramic cookware on your burner.
�
When you are finished with the burner, always turn the regulator control valve OFF first,
then the gas cylinder valve OFF.
�
The use of alcohol, prescription or nonprescription drugs may impair the consumer’s
ability to properly assemble or safely operate the appliance.
�
The installation of this cooker must confirm with local codes or in the absence of local
codes, with the National Fuel Gas Code
OUTDOOR
OUTDOOR
OUTDOOR
OUTDOOR USE
USE
USE
USE ONLY/
ONLY/
ONLY/
ONLY/ NEVER
NEVER
NEVER
NEVER LEAVE
LEAVE
LEAVE
LEAVE UNATTENDED
UNATTENDED
UNATTENDED
UNATTENDED
Cleaning
Cleaning
Cleaning
Cleaning instructions
instructions
instructions
instructions
1.
Remove the hose from the burner using a 7/16” wrench.
2.
Insert a small rod in the hole that the hose was removed from.
3.
Hold the burner up to a light looking into the hole that the hose was removed from to see
any obstructions.
4.
If burner has not cleared flush with water.
5.
Once the burner has cleared reassemble burner ( air shutter, spring, hose)
REGULATOR
REGULATOR
REGULATOR
REGULATOR CONTROL
CONTROL
CONTROL
CONTROL VALVE
VALVE
VALVE
VALVE OPERATION
OPERATION
OPERATION
OPERATION
Before using, turn the gas cylinder ON first, then the regulator control valve ON and light
burner. After use, turn regulator control valve OFF first, then the gas cylinder OFF (follow
lighting instructions)
If the hose and regulator shows signs of wear and needs replacing, please contact Customer
service for replacement parts.
