Glue the bottom fuse onto the Horizontal parts
NOTE: Ensure that you have already chamfered / bevelled the top AND bottom fuse parts (ie. Vertical
stab where the rudder will later be mounted) BEFORE doing this step.
IMPORTANT: Do NOT apply any glue to the tail rotor section that will be removed.
Use the foam templates (A and D) to help align the bottom fuse to the horizontal parts. If you prefer,
you can also use a right angle to help. Glue the bottom fuse piece onto the upside-down horizontal
parts. You should see the wing spars while doing this part. Ensure that the nose of the bottom fuse is
lined up with the nose of the horizontal parts.
Mount aileron and elevator servo linkages
Center the servos before performing the following steps and ensure the servo arms are physically
centred as well.
Ailerons
The kit has pre-cut slots for the aileron horns. Simply glue the horns in so that the desired hole
(probably the closest one to the control surface) is dead center over the hinge line.
Next use shrink tube and attach a Z-bend and a straight wire to each carbon pushrod. The straight wire
goes into the EZ-Link and the Z-bend goes into the control horn on the ailerons.
Note: Use sand paper to scuff the Z-bends and straight rods before shrinking the shrink tube. Then
use regular thin or super thin CA glue to wick into both ends of the shrink tube.
Install the Z-bend in the control horn and then the straight rod into the EZ-link.
Elevator
Glue the control horn onto the pre-cut slot on the elevator.
Similar to the ailerons, use sandpaper to scuff two Z-bends.
