ubbink Pool Filter 400, Manual

Page: 3 / 40

Pool Filter 400 / 500 / 600 - Pool Filter Sets 400-4m
3
/h / 400-6 m³/h / 500-9 m³/h / 600-13 m³/h
1
(1) The height of the silica filter sand shall not exceed 2/3 of the tank height.
You have purchased a technical device that it is simple and convenient to operate. Nevertheless, certain precautions are required to ensure the device performs as desired. Read this
manual carefully before you begin to install this product and store it in a place where you are sure to find it again.
To use the filter system, you will require a skimmer, i.e. either a built-in skimmer (integrated in the wood or steel wall) or a hanging skimmer (attached to the wood or steel wall).
Please note that proper function can only be guaranteed if the water is chemically treated in addition to the filtration. Consult your local dealer for further details and assistance about
water maintenance, water maintenance substances and chemicals as well as accessories, maintenance products and accessories.
Pool Filter
Safety Instru c tions
• The electrical service and connections shall comply with product specifications. Consult your local utility for specific information about the utility regulations, guidelines and s
pecifics. Do not connect the pump to the source of electricity if the electricity does not comply with specified instructions, regulations, standards and/or codes!
Consult your local electrician for further information.
• All electrical work shall be performed solely by qualified electricians.
• Never use an extension cord to connect the pump to the electrical service.
• The distance from the pump to the swimming pool shall exceed more than 2 metres.
• The source of electricity (electrical socket) shall be at least 3.5 metres from the swimming pool.
• The filtration group pump must be supplied by a circuit separation transformer or by a circuit comprising a residual differential current device (RDD),
of assigned operation differential current not exceeding 30mA (Class I swimming pool pump).
• If the electric cable is damaged, it must be replaced by a qualified person in order to avoid any danger.
• Never lift or pull the pump with the electrical cable and never pull on the electrical cable.
• Always shut off the power before disconnecting the electrical cable. Never work on the pump without first making sure that the power has really been shut off.
• This pump is not suitable for installation or operation in wet locations or underwater. Do not install it in swimming pools and do not allow it to fall into water.
• The pump is suitable for pumping water that does not exceed a temperature of 50° C.
• Do not operate the pump if it is not connected to a source of water, as this will lead to irreparable damage.
• The pump shall not be used by persons with limited physical, sensory or mental abilities or persons with insufficient knowledge and experience unless a person who is responsible
for their safety supervises such persons or unless the persons have been suitably instructed prior to using the product. Children must be carefully watched to ensure that they do not
play with the product.
• The filter shall not be used if it is not properly filled. The sand shall not exceed more than 2/3 of the tank’s capacity.
• NEVER touch the product with a wet body or wet hands if it is turned on. Make sure the ground surface is dry before beginning work or maintenance on the product.
• Neither adults nor children are to lean on the product or use it for support. Children must be carefully supervised to ensure that they don’t play with the product.
• Chemical products, such as chlorine, algaecides or water clarifiers shall under no circumstances be poured or placed in the pump’s sand filter or the preliminary filter basket and/or
the skimmer, as this may damage the product’s materials or reduce product performance.
• Use of the pool must be prohibitied if the filter system is defective.
• any damaged part of the filtration unit has to be replaced without any delay. Use only components approved by the supplier.
• When chemicals have been used to treat the pool water, it is recommended to maintain a minimum filtration time to preserve the health of bathers which depends on compliance with health rules.
• Do not operate devices that are obviously damaged! The power cable cannot be replaced. If the power cable is damaged, the device must be disposed of in the proper manner.
Pool Filter
400
Pool Filter
500
Pool Filter
600
Pool Filter Set 400
4 m
3
/h
Pool Filter Set 400
6 m
3
/h
Pool Filter Set 500
9 m
3
/h
Pool Filter Set 600
13 m
3
/h
Article No. EU 7514704 7514705 7504617 7504645 7504642 7504643 7504644
Sand filter
Filter - diameter(outer) 400 mm (16“) 500 mm (19“) 600 mm (24“) 400 mm (16“) 400 mm (16“) 500 mm (19“) 600 mm (24“)
Filter surface 0,125 m 2 0,180 m 2 0,260 m 2 0,125 m 2 0,125 m 2 0,180 m 2 0,260 m 2
Rated working pressure max. 3,5 bar max. 3,5 bar max. 3,5 bar max. 3,5 bar max. 3,5 bar max. 3,5 bar max. 3,5 bar
Rated filter flow max. 17 m³/h max. 17 m³/h max. 17 m³/h max. 17 m³/h max. 17 m³/h max. 17 m³/h max. 17 m³/h
Filter medium silica filter sand
Grain size (EN 12904:2005) 0.70-1.25 mm (TEN 0.75) 0.70-1.25 mm (TEN 0.75) 0.70-1.25 mm (TEN 0.75) 0.70-1.25 mm (TEN 0.75) 0.70-1.25 mm (TEN 0.75) 0.70-1.25 mm (TEN 0.75) 0.70-1.25 mm (TEN 0.75)
Silica filter sand capacity (1) max. 50 kg max. 75 kg max. 100 kg max. 50 kg max. 50 kg max. 75 kg max. 100 kg
Filtration values (EN 16 7 13-1)
Turbidity Reduction Efficiency (TBR) 83,2% 75,38% 77,81% 77,2%
Retained mass (DP20) 58,6 g (88%) 86,7 g (87%) 124,5 g (84%) 181,7 g (84%)
Retention Capacity (CR) 80 μm 165,44 g 152,43 g 117,04 g
Filtration Efficiency 45 μm (E45) max. 7 m³/h 38,9 μm 35,6 μm 70 μm
Filtration ratio 80% (S80) 70,70% 87,60% 88,90% 68,80%
Multi-port valve
Type TOP / Multi-port TOP / Multi-port TOP / Multi-port TOP / Multi-port TOP / Multi-port TOP / Multi-port TOP / Multi-port
Valves 6 6 6 6 6 6 6
Fittings 1 ½“ 1 ½“ 1 ½“ 1 ½“ 1 ½“ 1 ½“ 1 ½“
Suggested pump
Capacity (at 8 m water column) max. 7 m3/h max. 12 m3/h max. 16 m3/h
Pump in pool filter set Poolmax TP 35 Poolmax TP 50 Poolmax TP 75 Poolmax TP 120
Rated Voltage/Frequency 230 VAC / 50 Hz 230 VAC / 50 Hz 230 VAC / 50 Hz 230 VAC / 50 Hz
Rated Power 0.35HP/0.25kW 0.50 HP/0.37 kW 0.75 HP/0.56 kW 1.20 HP/0.90 kW
Electrical connector Plug with residual current (FI) circuit breaker, 30 mA, electronic, IP54
Flow rate (normal) 5.4 m3/h 126 m3/h 14,4 m3/h 18,0 m3/h
Filter capacity (sand filter) 4,6 m3/h 6,0 m3/h 9,0 m3/h 13,0 m3/h
Hose fittings (2 each) 38mm / 50 mm 38mm / 50 mm 38mm / 50 mm 38mm / 50 mm
TECHNICAL INFORMATION