UAV-1001101-001
Page
12 | 26
condensation for a period of 24 hours. Failure to provide for proper curing
of the silicone, may result in an improper seal of the area and leaks may
occur in the passenger compartment.
Place electrical cable in most appropriate and convenient manner from the
roof penetration to the electrical source and secure with plastic or metal tie
wraps to minimize rattles during operation.
The cable is then attached to the power supply, per the guidelines in
section “Connection to Vehicle Electrical System”.
7.3 Connection to the Vehicle Electrical System
ABSOLUTE MAXIMUM DC VOLTAGE GREATER THAN 36 V
DC
WILL CAUSE
PERMANENT DAMAGE TO THE EQUIPMENT
Vektor shall be connected to the vehicle electrical installation via the
supplied wiring harness. Wiring harness is comprised a single 3 meter,
solid copper, 2 lead, 16 gauge cables with each Vektor.
Use a 1 Amp
circuit breaker for power supply protection to the Vektor.
Wire Color
Function
Red
Vehicle Power
Black
Vehicle Ground
The external sheath of the supplied cable is tough, shear-resistant and
resistant to mineral oils and abrasion. During the installation, it is necessary
to ensure the bend radius of the cable is no greater than a minimum bend
radius of 22mm.
For units equipped with a cigarette lighter adaptor terminated wiring
harness, the electrical installation is simply to plug the adaptor into the
cigarette lighter.
