USWD500 User’s Manual Version 3.0
- 19 -
Step 6
The "CONNECT" message
When UDP mode is
disabled
, use the
ATD
command for connection setup as
follows:
ATD
Dial when UDP is disabled.
CONNECT
The connected message (and enter on-line mode).
When the “
CONNECT
” message is displayed, it means the USWD500 Modem is
successfully connected to the remote terminal. You are already in
ON-LINE
mode
and ready to start transmitting and receiving data. For example:
ATD;
Dial when UDP is disabled.
CONNECT
The connected message (and back to command mode).
The “
;
”
dial modifier
is used to return to
Command
mode after your connection
setup is complete. You can also use the
ATS57
command to check the connection
status. For more information about the
ATS57
command and
ON-LINE
mode,
refer to
“Useful Commands”
on Page 26.
When UDP mode is
enable
d, use the
ATD(
remote address
)/(
remote port
)
command for connection setup as follows:
ATD203.67.40.254/7
Dial and enter on-line mode when UDP is
enabled.
CONNECT
...or
ATD203.67.40.254/7;
Dial and back to command mode when UDP is
enabled.
CONNECT
Step 7
USWD500 Disconnection
To disconnect from the CDPD network, use the
ATH
command that best applies to
your situation, as described in
Appendix A “AT Command List”
on Page 43.
