Part # 4523341 Rev 2 (03/04/10)
Page 8
The installation must conform to the National Fuel Gas Code
ANSI Z223 .1, or latest edition, NFPA No .54- latest edition/or
local code to assure safe and efficient operation . In Canada,
the installation must comply with CSA B149 .1 and local
codes .
Gas Connection
The local gas authority should be consulted at the
installation planning stage in order to establish the
availability of an adequate supply of gas and to ensure
that the meter is adequate for the required flow rate . The
pipe work from the meter to the appliances must be an
appropriate size .
All fixed (non-mobile) appliances MUST be fitted with an
accessible upstream gas shut off valve as a means of isolating
the appliance for emergency shut off and for servicing . A
union or similar means of disconnection must be provided
between the gas-cock and the appliance .
A manually operable valve must be fitted to the gas supply
to the kitchen to enable it to be isolated in an emergency .
Wherever practical, this shall be located either outside the
kitchen or near to an exit in a readily accessible position .
Where it is not practical to do this, an automatic isolation
valve system shall be fitted which can be operated from a
readily accessible position near to the exit .
At locations where the manual isolation valve is fitted or
the automatic system can be reset a notice MUST be posted
stating:
“ALL DOWNSTREAM BURNER AND PILOT VALVES MUST
BE TURNED OFF PRIOR TO ATTEMPTING TO RESTORE THE
SUPPLY . AFTER EXTENDED SHUT OFF, PURGE BEFORE
RESTORING GAS .”
Electrical Connections (Where Applicable)
IMPORTANT- This appliance must be electrically grounded in
accordance with local codes, or in the absence of local codes
with the National Electrical Code .
220/240 Volt Convection Oven Models
When the appliance is ordered and equipped for 220/240
volt operation, the supply line must be connected to the
wiring terminations located inside the terminal box at the
rear of the appliance .
INSTALLATION Continued
For ease of attaching the supply line, there is a removable
cover on the terminal box .
Permanent connection to the electrical service must comply
with local codes, or in the absence of local codes, with the
national electrical code .
Installation Notes
Before assembly and connection check gas supply .
A . The type of gas for which the unit is equipped is stamped
on the data plate located behind the lower front panel .
Connect a unit stamped “NAT” only to natural gas;
connect one stamped “PRO” only to propane gas .
B . If it is a new installation have the gas authorities check
meter size and piping to assure that the unit is supplied
with necessary amount of gas pressure required to
operate the unit .
C . If it is additional or replacement equipment have the gas
authorities check pressure to make certain that existing
meter and piping will supply fuel to the unit with no
more than 0 .15 Kpa pressure drop .
D . Make certain new piping and connections have been
made in a clean manner and have been purged so that
piping compound, chips, etc . will not clog pilots, valves or
burners . Use pipe joint compound approved for natural
and liquefied petroleum gases .
NOTE: Gas pressure should be checked when the unit is
installed and all other equipment on the same line is on . The
operating gas pressure must be the same as that specified
on the rating plate . If necessary, pressure adjustment may be
made at the pressure regulator supplied with the appliance .
The appliance and its individual shut-off valve must be
disconnected from the gas supply piping system during any
pressure testing of that system where pressures are in excess
of 1/2 PSIG (3 .45kPa .)
Final Preparation
NOTE:
Your new range has a plastic coating to help protect
the finish from scratches during shipping . This protective
plastic film should be peeled off prior to starting the range .
Summary of Contents for U.S. Range U SERIES
Page 16: ...Part 4523341 Rev 2 03 04 10 Page 16...
Page 56: ......
