background image

INSPECTION:

Carefully unpack and inspect your COBRA PLUS-150 for shipping damage.  Each machine is
tested and inspected before shipping.  Any shipping damage incurred is the responsibility of
the carrier.  You should notify the carrier immediately if you notice damage to the box or to
the machine or parts.

CLEANING SOLUTIONS:

We recommend liquid cleaning chemicals, such as our Magic Fabric Cleaner.  Powder chemicals
may be used, but unless mixed very thoroughly they could cause a build-up in the pump,
lines, heat exchanger and/or quick disconnects.  Any problem caused by a chemical build-up
is not covered by warranty.  Use a neutral cleaner with a pH between 6 and 9 to avoid
premature wear of the pump, seals, and/or other components.  Damage caused by the use of
strong chemicals is not covered by the warranty.

MAINTENANCE:

For optimum performance flush the machine with clear water at the end of each working day.
Once a month, minimum, run a flushing compound  through the machine to break up any
mineral or chemical build-up that may have formed.  U.S. Products “X-1500” is recommended.
Lubricate the wheels, castors, and quick disconnects with an all purpose silicone spray.  The
vacuum and the pump do not require any maintenance; however the vacuum motors may
require new brushes after 1000 - 1500 hours.  Clean the body with an all purpose detergent,
and protect it with an all purpose silicone spray like automobile interior polish.

RECORD AND KEEP THE FOLLOWING INFORMATION

And don’t forget to register your puchase to activate your warranty;

go on-line to www.usproducts.com or complete and return your warranty card

Serial Number: __________________
Model: CP-150_
Purchase Date:
_____________
Write the name and phone number of your distributor:

Summary of Contents for COBRA PLUS-150









Reviews: