SKU 93663
For technical questions please call 1-800-444-3353
Page 6
NOTE: The green LED will remain on until the battery pack is removed from the
charger, or the charger is disconnected from the power source.
8.
After normal use, a minimum of 1 hour recharging time is required to recharge a battery.
9.
During recharging, the battery pack will become slightly warm to the touch. This
is normal and not a cause for concern.
10. When the battery is fully charged, as indicated by the green LED, unplug the
battery charger and remove the battery pack. Do not leave the battery in the
charger indefinitely.
Operation
1.
To turn ON the Work Light, press the ON/OFF Switch on the back of the tool. To
turn OFF the tool, press the ON/OFF Switch again. The Work Light will normally
work for 5-6 hours when starting with a fully charged battery.
2.
The Work Light has a Hook built into the back for hanging the light in a convenient
location. To use the Hook, grasp it and rotate upward. To store the Hook, rotate it
back into place.
Maintenance
1.
When not in use, store it in a dry, secure location. Charge the Work Light before
storage.
2.
Whenever the RED Indicator Light comes on, recharge the Work Light. The light
will operate for approximately 5 minutes after the Red light comes on.
3.
This item is water resistant, but is not designed to be submerged in water.
Battery Replacement
CAUTION: Only a qualified service technician may replace the batteries.
To access the batteries, remove the two screws on the underside of the light.
The batteries must be replaced only with batteries of the same type and size.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN
THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DIS-
TRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER
THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR
SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFAC-
TURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS RE-
PLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS
AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF
HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO,
OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
