Page 4
SKU 47860
Operation
Warning: The brass components of this product contain lead, a chemical known to the
State of California to cause birth defects (or other reproductive harm). (California Health
& Safety Code 25249.5 et seq.)
1.
Turn vehicle ignition off. Always activate the emergency brake when working on the
vehicle.
2.
Depressurize brake system by pumping brake pedal (to the floor) at least 20 to 40 times.
When you feel a pronounced increase in pressure against your foot, pump the pedal
three more times.
3.
Refer to the vehicle service manual to find the correct location to attach the test
assembly.
Caution: Wear approved safety glasses to avoid brake fluid from contacting the eyes. Do
not allow brake fluid from contacting and damaging the vehicle paint.
4.
Attach the test adapter (See Parts Drawing for available sizes).
For Teves Systems:
a. Remove accumulator (with O-ring) from pump body.
b. Thread desired Adapter (shown below) into the pump body.
c. Install the accumulator onto the Adapter as shown.
Caution: The brake fluid is under extremely high pressure. When pressure testing Teves
Systems, do not open the bleed valve when the accumulator is charged. Check to be
sure that it is tightly closed before turning the ignition on to start the pump.
