Page 7
SKU 47558
17.
Plug the Cement Mixer Power Cord into an electrical outlet, and turn the Switch on.
Allow the Cement Mixer to operate dry for a few minutes. This should help align the
Motor Pulley and Drive Pulley.
18.
Unplug the Power Cord from the electrical outlet.
19.
Tighten all Motor mount and Inner Belt Cover nuts and bolts.
20.
Place the Outer Belt Cover (45) onto the Inner Belt Cover (41) and secure with the
knob Screw (46).
21.
Glue the Drum Seal (48) to the mating surfaces of the Upper Drum (3) and the Lower
Drum (9).
Place enough glue to cover the Drum Seal surface on each Drum. Press the Drum
Seal over the glue. Do not cover the Drum holes with glue. Make a complete circle on
each Drum. Allow 40 minutes for the glue to dry. Cut off excess Drum Seal with a
razor blade. Using a sharp object, punch holes through the Drum Seal where the
mounting holes are located.
22.
Raise the Upper Drum (3) and place it on the Lower Drum (9), aligning the mounting
holes. Using Hex. Bolts (2), Spring Washers (6), and Hex. Nuts (7), securely mount
the Upper Drum to the Lower Drum.
Note: Before doing this, make sure that the Mixer Blade (1) mounting holes on the
Upper and Lower Drum are aligned over each other. If they are not, rotate the Upper
Drum.
23.
Place the Mixer Blades (1) in the Drum so that the bend in the middle of the blade is
pointing in a clockwise direction. Place the Hex. Bolt (2) through the lower Mixer Blade
hole, and through the Lower Drum. On the outside of the Drum, use a Pater Washer
(4), Set Washer (5), Spring Washer (6), and Hex. Nut (7). Do this with the Mixer Blade
upper mounting hole. Repeat this step for the other two Mixer Blades. See photo G.
(2), (4), (5), (6), (7)
(1)
(1)
(1)
[G]
