10
Step 4: Install Your Module
Use your U.S. Cellular
®
smartphone to check that you
have a strong signal where your vehicle is parked.
•
Make sure your vehicle is parked outside
in a safe location and the engine is turned
off.
•
Now plug the module into the OBD port
(or into the extension cable if it is
required).
Make sure that the module is
fully seated.
•
Wait for the Status LED to turn solid blue.
For helpful installation Tips
– See
delphiconnect
.com/install
Step 5: Initiate Module Setup
Stop!
Do not proceed until the Status LED is solid blue,
indicating activation on the U.S. Cellular
®
network.
•
Insert your
vehicle’s ignition key and turn it to
the on position (not ACC/Accessory).
Do not
start the engine!
• Typically, all of the warning lamps on the
dashboard will illuminate briefly in this position
• For pushbutton-start vehicles, the procedure
is typically to push the start button without
your foot on the brake (check your vehicle
owner’s manual to determine how many
presses are required to turn the ignition on).
