II. Function Introduction
II. Function Introduction
1. Copy
It copies data from source Flash device to target Flash devices. The default setting of
copy area is “Data Only”. If you like to change copy area from “Data Only” to “ Whole
HDD” or “All Partitions”, please refer to function [5.1 Copy Area] for selecting the copy
modes
Steps of copy:
Plug source and target Flash devices into duplicator→Select [1. Copy]→Press
[OK]→The LCD will show the number of target flash plugged in and ready for
copy→Copy processing→Copy finished→Press
[ESC] to finish copy.
In < Data Only > Mode:
** Do not take out any Flash device while the program is processing.
** It is strongly recommended that target and source have to be in the same capacity.
** After copy, the target flash cards' data and format will same as source flash card. Original
data in target flash cards will be no longer existed.
** When the program is in process, the green LED will flash. When the process has finished the
green LED will stop flashing but will remain illuminated. If an error occurs the red LED will
illuminate.
USB Duplicator
1. Copy
USB
3817M
Reading Content
OK
USB (3817M)
870M
1. ready
OK
Copy 870M
21% 0:20 275M
TOTAL OK:1 NG:0
1:24 OK:1 NG:0
Copy 870M
21% 0:20 275M
Copy progress
Copied Size
Total Data Size
Time (mm:ss)
5
