8
Function Introduction
1. Copy
The copy function copies data from source HDD to target HDD. You can set
following settings before copy. (You can check more detail in ”6. Setup”.)
I.
Set Copy Area of Source HDD → 6.1 Copy Area
II.
Set Copy Unknown Format Area → 6.4.1 Unknown Format
➢
Start to copy
Step 1: Prepare Source & Targets
Prepare a source HDD and target HDDs.
(It’s strongly recommended that the source and target are the same capacity.)
Caution
Various adapters are required to copy devices with different
interfaces, e.g. IDE, eSATA, mSATA, and etc.
Step 2: Connect Source & Targets
Connect source HDD to source port, target HDDs to Target ports.
Step 3: Enter Function "1.Copy"
Use
▲▼
to select "1.Copy", and then press "OK". Duplication will start.
Note
If the user set “6.4.4 Wait HDD Time” at 3
-30 seconds, the
machine will start duplicating automatically after HDDs initialize.
If “wait key to start”
is set, user needs
to press “OK" to start.
