16
Figure 8a.
Fixing holes marking, modification 2
Connect the power wiring
Modifaction 2 (see Fig. 8b):
Perform the marking of
holes
using
the
accompanying drawing;
Fix the enclosure;
Connect the wires
Communication
U-Prox HE uses wired computer networ for connection to U-Prox IC L. Device setup
is possible with using autoconfiguration or manually with a PC using the software
"Configurator".
Appropriate configuration provides:
static or dynamic (DHCP) IP address assign to the repeater
operation with two (main and backup) IP or DNS (computer domain name)
U-Prox IC L addresses
operation in the Internet network with route backup possibility via the
second redundant router
U-Prox HE repeater operates in automatic mode. It routes event message data from
the allowed U-Prox IP500 wireless panels to U-Prox IC L panels connected to the
Ethernet computer network after the configuration data download.
The repeater communicator operates in the
notification
mode that means that data
transmission to U-Prox IC L panel is initiated on the access event.
Operating in the computer network U-Prox HE repeater provides encryption
protection of the data and commands with 256 bit key, unique serial number
supervision and communication channel supervision with periodical test messages.
Wired computer network
The Ethernet interface used for device connection into the network and for device
powering with PoE technology. The Ethernet cable must not exceed 100 meters
without use of additional equipment. The data transmission speed is 100Mbit/sec.
The Ethernet connection examples are on the Fig.9.
