PAGE 4 OF 30
0821 IH-9464
ASSEMBLY
1. Verify that the power cord is
disconnected from the outlet.
(See Figure 1)
2. Undo the latches. (See Figure 2)
3. Lift the power head off collection
tank. (See Figure 3)
4. Remove the contents from inside
the collection tank and ensure
all contents are present.
(See Figure 4)
5. Turn the collection tank upside
down and insert the four
caster feet into the slots on the
collection tank. Tighten with
supplied screws. Verify that the
casters are mounted correctly.
Do not overtighten screws.
(See Figure 5)
6. Position the hose storage rack as
illustrated. Fully insert one end of
the hose storage rack into the slot
illustrated by the arrow.
(See Figure 6)
7. Pull the other end of the hose
storage rack to align with
the corresponding arrow
(See Figures 7-8)
8. Insert into the slot until it is
secured in place. (See Figure 9)
NOTE: Vacuum comes ready
for dry vacuum cleaning.
9. For wet vacuum cleaning,
remove the cartridge filter and
replace with the supplied foam
wet filter. See filter installation
instructions on pages 8-9.
10. Place the power head back on
the collection tank and secure
into place using the two side
latches. (See Figures 10-11)
11. Insert the locking end of the hose
into the port on the collection
tank and turn to lock into place.
(See Figure 12)
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 8
Figure 10
Figure 11
Figure 12
Figure 9
Figure 7
