u-line.com
9
Removing Existing Drawer Fronts
1. Open drawer. Pull drawer gasket out of
groove (top edge of drawer only). Start in
the middle and pull outward, moving
toward the edge. This may take some force.
2. Remove the two screws located at the ends
of the handle. Remove the handle.
3. Remove existing vinyl panel and cardboard
spacer. Discard the spacer.
4. Reinstall handle.
5. Repeat for both drawers.
Preparing the Drawer Frame for Overlay
You have received your drawers with or without holes
pre-punched into the galvanized steel. If your door does not have
the punched holes, please use diagram below for hole location
dimensions.
Preparing Steel Insert
1. With the drawer open and braced, drill 6 holes into the steel
plate and through the frame using the pre-punched holes as a
guide. If your panel is not pre-punched, see diagram below for
hole locations. Repeat for both drawers.
Note:
Hole location dimensions will not line up with holes in
pre-punched panel.
Note:
Be sure to drill completely through frame.
Panel Installation
1. Place prepared panel against drawer front and secure with
clamps.
2. Be certain the panel is aligned flush with the top of the drawer
handle.
3. Using a #6 Drill bit, drill 8 pilot holes into the wood panel 3/8"
deep.
NOTICE
It is important to ensure that all drilled holes are drilled to
the correct depth in order to avoid splits in the wood
when hardware is installed.
4. Locate the 8 #6x2" screws provided in the overlay panel install
kit.
5. Using a Phillips head and #6x2 screws, screw the drawer panel
to the drawer front.
6. Be sure the screws force their way past the opening on the
gasket channel and sit flush against the bottom of the gasket
channel.
7. Repeat for both drawers.
Assembling the Drawer Front
NOTICE
The bottom of the lower overlay panel will line up with the
bottom of the adjacent cabinetry and may not line up with
the bottom of the actual drawer itself. See graphic below.
1. Starting at the corners and working toward the center, push
the drawer gasket back into place. Repeat for both drawers.
4-1/16"
9-1/16"
11/16"
7-5/16"
9-5/16"
Steel Plate
Top Down Slice
View
Bottom Of Panel
Drawer Reveal
Panel
Toe Kick
