PAGE 2 OF 3
0514 IH-2861
LoaDing instructions
lOADInG THE BATTErIES
1. To load the batteries, locate the compartment inside
and towards the bottom of the dispenser.
(See Figure 4)
2. remove the compartment cover by sliding the cover
left to unlock.
3. Place batteries into compartment according to the
battery diagrams on the inside of the compartment.
(See Figure 5)
4. replace battery compartment cover and slide to
the right to lock.
note: three red lights will appear on the
dispenser sensor when batteries are properly
loaded.
2. Open dispenser cover completely and hold dispenser
to ideal mounting place on wall. (See Figure 2)
3. using a pencil, mark the four holes on the wall where
screws will be inserted. (See Figure 2)
4. Set dispenser aside and drill into wall at four marked
locations with an appropriate drill bit. (See Figure 3)
5. Hold dispenser to wall so that the holes in the wall
and the dispenser match up. Insert four screws into
previously drilled holes.
mounting instructions continueD
Mounting
Holes
Figure 4
Figure 5
Figure 2
Figure 3
