PAGE 9 OF 30
0721 IH-8097
SHOP-VAC
®
VACUUM FILTER CLEANING REFERENCE
Foam Sleeve
Full Polyester Sleeve
Super Performance Filter
Reusable Disk Filter
Cartridge Filter &
Ultra Web
®
Cartridge Filter
All Collection Bags
CleanStream
®
Abrasion-
Resistant Cartridge Filter
FILTER
CLEANING INSTRUCTIONS
Foam Sleeve
Rinse with water, dry and reinstall.
Full Polyester Filter
Brush off dirt and reinstall; if filter gets wet, rinse with water, dry and
reinstall.
Super Performance Filter
Dispose of after filter develops rips or tears.
Reusable Disk Filter
Rinse with water, dry and reinstall.
Important:
do not machine wash.
CleanStream® Abrasion-
Resistant Cartridge Filter
Clean installed filter by tapping or shaking the vacuum unit. To restore
optimum airflow, remove filter and tap end cap against a hard
surface to loosen debris. Additional debris can be removed by rinsing
outside surface of filter with running water. Avoid dampening inside of
filter. Completely air dry filter after washing.
Important:
DO NOT brush.
DO NOT clean filter media with abrasive materials. DO NOT scrub to
clean between pleats. This will permanently damage the filter's ability
to stop dust.
Cartridge Filter and Ultra Web®
Cartridge Filter
From inside of filter, rinse with water, dry completely and reinstall.
All Collection Bags
Dispose of bag when full.
DAILY
1.
Filter
– Check cartridge filter for clogs or heavy
soiling and replace if necessary. Ensure that correct
filters are being used for the task – see the Filters
section on page 5 of the instruction manual.
2.
Collection Bag
– If using collection filter bag, check
to ensure that there are no rips/tears in the bag and
that the bag is not full.
3.
Tank
– If vacuuming up wet or damp material,
empty the tank after use, as musty odors may occur
if debris is left inside.
4.
Extension Cord and Plug
– Check extension cord
and plug for any cuts or damage. If damaged,
replace motor housing unit.
5.
Motor
– If there are unusual sounds or if poor
performance occurs, the motor should be inspected
immediately by the Uline service team.
WEEKLY
1.
Wands/Tools
– Inspect wands and tool attachments
for any damage. Replace if necessary.
2.
Hose
– Inspect hose for any damage and replace if
necessary.
MONTHLY
1.
Cleaning
– Inspect and clean all areas of the
vacuum, including inside of tank.
ROUTINE MAINTENANCE
