PAGE 2 OF 6
0921 IH-9593
INSTALLATION CONTINUED
INSTALLING WITH WALL FASTENERS (OPTIONAL)
1. Using back plate as template, mark and drill center
holes into wall using 1/4" spiral masonry drill bit or 1/4"
wood drill bit (not included). (See Figure 4)
Figure 4
2. Install #10 x 1" anchors (not included) into drilled
holes, flush against surface. Insert type #10 x 1"
fasteners (not included) into four installation holes
in back plate, through installation tape. Tighten
fasteners securely. Be careful not to overtighten.
(See Figure 5)
Figure 5
LOADING DISPENSER AND USAGE
1. Open dispenser by pressing release button on
bottom and allow front cover to descend forward.
(See Figure 6)
Figure 6
2. Remove empty refill and recycle.
3. Remove fill cap and push the new refill into
dispenser until it clicks into place. (See Figure 7)
Figure 7
Cap
Refill
4. Close dispenser cover.
5. Place hand in middle of bar and push several times.
Product will dispense as bar is depressed.
(See Figure 8)
Figure 8
Bar
1-800-295-5510
uline.com
