PAGE 2 OF 9
0721 IH-8656
4. Lift fan head and align it with the fan head support
pole. Once the fan head is seated on the support
pole, rotate fan head horizontally until it engages
with support pole. (See Figure 2)
NOTE: Once installed, the atomizer (metal disk)
will face the water tank.
5. Plug into a 110V or 220V outlet equipped with GFCI.
LED lights on the control panel will illuminate.
CAUTION! Do not plug into standard outlet
without the GFCI feature.
SETUP CONTINUED
Figure 2
Fan Head
Water Tank
Atomizer
Fan Head
Support Pole
OPERATION
Figure 3
Fan Head
Power Cord
Atomizer
Drain Hose
Water Inlet Hose
Control Panel
1. Add water to the tank.
NOTE: Do not fill the water tank above the max
fill level.
2. Route the fan head power cord, atomizer drain hose
and water inlet hose through the openings in the
back of the water tank. (See Figure 3)
3. Misting level can be adjusted using the water valve
located inside the tank. To increase mist, turn the
lever counterclockwise. (See Figure 4)
4. Slide lid into notch in back of water tank. Lower front
of lid and re-lock lid latch.
5. To fully drain the water tank, turn and open the drain
plug counterclockwise. (See Figure 5)
MAX FILL LINE
Figure 4
Water Valve
Figure 5
