02/2005
9
www.U-LineService.com
SP18 Ice Maker
Leveling Information
IMPORTANT
It is extremely important that the unit sits on a level
surface, as it does not have feet levelers. If it is not level,
the ice mold will not fill evenly.
Use a level to check
the levelness of the
unit from front to
back and from side
to side. Level
should be placed
along top edge
and side edge as
shown (see
Figure
19
). Go on to
8 Install the Unit
.
Installation of the SP18
1. Open the water supply valve in the main water source.
2. Plug in the power cord.
3. Gently push the unit into position. Be careful not to
kink the water supply line or entangle the electrical
cord.
4. Re-check the leveling, from front to back and side to
side. Make any necessary adjustments.
5. Secure the flange to the frame structure using the four
holes in the flange. The type of fasteners will depend
on the structure you are mounting the flange to.
Installation Troubleshooting
Problem
Q:
Water is leaking under the unit.
Solution
A:
A water leak under the unit is most likely caused by a bad
connection in the water supply line. Make sure the water
line’s brass fitting is screwed tight to its valve and
threaded correctly. Make sure that plumbers tape was
NOT used; if it was remove all traces before reinstalling.
7 Level the Unit
Check
Level
Figure 19
8 Install the Unit
