06/2006
9
www.U-LineService.com
1175R, 1175WC and 1175BEV Models
2. Pull door gasket out of
groove (top edge of door
only). Start in the middle
and pull outward, moving
toward the edge (see
Figure 13
). This may take
some force.
3. Remove two outside
screws holding door
handle. Slightly separate
door handle from door
(see
Figure 14
).
4. Pull handle up and off.
IMPORTANT
Use care not to damage magnet , located on door bottom
when installing door insert. Do not set door on bottom
edge when pushing insert into place.
5. Slide custom door panel insert into 1/4-inch channel in
door front.
6. Holding door gasket out of the way, replace handle on
door, making sure it is seated properly on insert and
that screw holes line up.
7. Install two small screws removed in
Step 3
.
8. Starting at the corners and working inward, push door
gasket into place on door.
9. Place door on bottom hinge pin and install upper hinge
screw.
10. Go on to
5 Adjust Door
.
CAUTION
To prevent permanent damage to the inner liner of the
Beverage Center and the Wine Captain, the wine rack
wood trim MUST be removed from the unit for staining
and/or finishing. Allow stain/finish to dry thoroughly (at
least 24 hours per coat) in accordance with the stain/finish
manufacturer’s instructions prior to re-installing the wood
trim inside the cabinet of the Beverage Centeror the Wine
Captain. Failure to do so may cause the inner liner of the
unit to have a permanent odor, which is not covered by
the warranty.
Adding a Final Finish Coat to Wood
Trim
(75BEV Beverage Center and 1175 Wine Captain Units)
To remove a rack from the cabinet:
1. Grasp the end of the rack, and gently slide it out until
it stops.
2. Remove any bottles stored on the rack.
3. Press the left rack release lever
(Figure 15)
down, and
at the same time, lift the corresponding right rack
release lever up, and pull the rack out until it is free of
the tracks and the cabinet.
IMPORTANT
Do not remove the track side rails from the cabinet.
To insert a rack in the cabinet:
1. Align the left and right rack channels with the tracks
in the cabinet, and ensuring an even track
engagement on both sides, gently push the rack into
the cabinet until it stops.
2. Before reloading the rack, ensure proper operation of
the travel stops in the left and right track rails by
pulling the rack out gently until it completely stops.
Figure 12
Figure 13
Figure 14
ULIN_0162_A
Figure 15
