PAGE 3 OF 9
0222 IH-9924
FAN HEAD ASSEMBLY INSTALLATION
NOTE: Do not operate if the finger guards are
missing, damaged or not fitting properly. Do
not use if the cord or connector has exposed
wires or is damaged in any way.
MOBILE PEDESTAL ASSEMBLY
CAUTION! Use care when selecting a location
for the fan. Do not place the fan on a sloped
surface.
1. Place mobile pedestal base on a flat surface.
(See Figure 4)
2. Secure the yoke to pedestal base by inserting the
5/8" bolt through the center hole in the yoke and
through the hole in the pedestal base arm. Secure
with 5/8" nut and tighten securely using a 16 mm
wrench. (See Figure 4)
NOTE: Use care when repositioning fan or
mobile pedestal. Do not attempt to adjust fan
or pedestal while the fan is running.
WALL BRACKET ASSEMBLY
NOTE: Fan can be placed above the wall
mount assembly or hung down below.
1. Secure part A of wall mount assembly bracket to
solid surface from which fan will be hung. A single
mounting hole is located on part A. Secure to
surface using a wall anchor (not included).
(See Figure 5)
2. Position part B under A and situate B so that A is level.
A single mounting hole is located on part B. Secure
part B to surface using a wall anchor (not included).
(See Figure 5)
3. Using a 16 mm wrench, secure the yoke to wall
mount assembly bracket by inserting the 5/8" bolt
through the center hole in the yoke and through
the holes in both parts of the wall mount assembly
bracket. (See Figure 5)
NOTE: The yoke may open up or down
depending on which way the wall mount
assembly bracket is hung. Check for level and
stability.
NOTE: A safety chain (not included) is
recommended for securing fan head.
1-800-295-5510
uline.com
Figure 4
Figure 5
Pedestal Base
Yoke
Yoke
Finger Guard
Wall Mount
Assembly Bracket
Mounting Hole
A
B
Fan Head
Assembly
Fan Head
Assembly
