PAGE 2 OF 9
0322 IH-8205
ASSEMBLY
1. Place front, back and side panels upright. Align all
panels. (See Figure 1)
NOTE: Panels will be upside down for first part
of assembly.
2. Using a 16 mm wrench, attach side panels to front
and back panels at each corner inserting one long
bolt and one large flat washer into threaded nuts.
(See Figure 1)
NOTE: Do not fully tighten bolts.
3. Insert feet into side panels at desired height. Using
a 16 mm wrench, attach feet to side, front and
back panels with two long bolts and two large flat
washers per corner. (See Figure 2)
NOTE: Top adds approximately 2" to total height
of unit. If mobile, casters and top combined will
add approximately 7
½
" to height.
4.
For Mobile Workbenches Only:
Attach casters with four
short bolts, four medium flat washers, four medium lock
washers and four medium nuts using a 17 mm wrench.
Put casters into locking position. (See Figure 3)
5. Flip workbench right side up. (See Figure 4)
6. Tighten all bolts with a 16 mm wrench.
7. Center shelf has three height options. Choose
preferred height. Using a 10 mm wrench, attach
back panel shelf mounts to back panel on each
side by inserting one M6 x 15 mm hex bolt and one
small flat washer into threaded nut. (See Figure 4)
NOTE: Do not install front panel shelf mount.
8. To attach tabletop, carefully place and center
tabletop onto workbench. Using the mounting plates
as a template, drill pilot holes into tabletop about
1/2" to 3/4" deep with a 3/16" drill bit.
Figure 1
Figure 2
Figure 3
Figure 4
Shelf
Mount
Mounting
Plates
