PAGE 3 OF 15
0118 IH-7191
BLADE REPLACEMENT
WARNING! Not following instructions may cause
injury to user.
1. Remove four screws and pull protective shield out.
(See Figure 8)
2. Lift handle approximately 60° up to allow insertion of
safety pin into hole. (See Figure 9)
3. After insertion of pin, confirm safety pin protrudes
through other side. (See Figure 10)
NOTE: The safety pin now blocks the movement
of handle.
4. Put tool down to horizontal position. Use Allen wrench
to free screws and washers. Remove two cutter
blocks. (See Figure 11)
5. For safety reasons, use included magnet to hold
new blade. (See Figure 12)
6. Using magnet, place blade against pins as shown.
(See Figure 13)
Figure 8
Figure 9
Figure 10
Safety Pin
Figure 11
Figure 12
Figure 13
Cutter Block
Pin
60
º
