PAGE 5 OF 21
1120 IH-7155
ATTACHING THE ROLLOVER STRAPS AND
LOCK DOWN STRAPS
NOTE: The "D"
rings, pull straps, footman loops
and rollover straps are already attached. One
end of the rollover strap is attached to bottom
of screen. (See Figure 16)
1. Pull the screen down to release the two rollover straps.
Slides are attached to each strap. Make sure the
straps are laying flat and not twisted. (See Figure 17)
2. Feed the strap through the footman loop that has
been pre-attached to the guide track. Then, take
the strap back through the slide as shown in the
illustration. Adjust the strap so it is taut when the door
is in the open position. Repeat on other side.
(See Figure 18)
3. Once rollover straps are set, pull screen to the down
position and take the short lock straps with snap
hooks and snap the hook into the "D" ring.
(See Figure 19)
4. Take the other end of the lock strap and pull it at a
diagonal so the strap grommet is centered on the
front of the guide track. Mark the hole. (See Figure 20)
5. Place screen in the open position and drill the pilot
hole for the lock strap hardware (supplied).
ASSEMBLY CONTINUED
Figure 17
Slides
Figure 18
Slide
Footman Loop
Figure 19
"D"
Ring
Snap
Hook
Lock
Strap
Figure 16
Guide Tracks
"D" Rings
Footman
Loop
Footman
Loop
Pull Straps
Lock Straps
Rollover Straps
Figure 20
