0621 IH-5871
PAGE 2 OF 15
ASSEMBLY CONTINUED
Figure 2
Figure 3
Figure 4
Figure 5
2. Attach a leg brace to each table leg as shown
using two small screws. (See Figure 2)
NOTE: There are two types of tabletop supports.
Tabletop support #1 has four holes – two of
which are very close to each other at one end.
Tabletop support #2 has four holes – two very
close to each other near the center. One of
each will be required for each of the three leg
assemblies. (See Figure 3)
3. Set a tabletop support #2 onto a table leg. Align
the holes on the support with the holes in the leg as
shown. Insert two 35 mm bolts and secure with cap
nuts as shown. Tighten by hand only. (See Figure 4)
4. Set a tabletop support #1 onto tabletop support #2
and the table leg. Align the holes at the end of the
support with the holes in support #2 and the leg as
shown. Insert 35 mm and 38 mm bolts as shown and
secure with cap nuts. Tighten by hand only.
(See Figure 5)
5. Repeat steps 3-4 for the other two table legs.
Small
Screws
Leg Brace
Tabletop Support #1
Tabletop Support #2
Tabletop Support #2
35 mm
Bolt
Cap Nut
Tabletop
Support #1
Tabletop Support #1
35 mm Bolt
38 mm Bolt
Cap Nuts
