PAGE 8 OF 33
0819 IH-5819
5. Add additional items to platform. New data will be
added to memory. Continue until all data is added.
6. To recall data and clear data, see sections above.
UNIT WEIGHT MEMORY
The scale can store and recall up 255 unit weights.
SETTING A UNIT WEIGHT
1. Key in the unit weight by using the numeric keys.
2. Press and hold the
PLU
key
PLU
.
PLU
will be shown
on the display.
3. Key in the unit weight name using the numeric keys.
Names should be three digits between 001 and 255.
4. Once keyed in,
SAV###
will be shown on the
display. The scale makes a beeping sound and
enters the counting mode.
RECALLING A UNIT WEIGHT
1. Place items to be counted on the platform.
2. Press the
PLU
key
PLU
.
PLU
will appear on display.
3. Key in the three digit unit weight name by using the
numeric keys.
PL
###
will be shown on the display.
4. Scale will recall the unit weight and then display the
number of items on the platform.
RS-232
1. Specifications:
• RS-232 output of weighing data
• ASCII CODE
• 600-9,600 Baud
• 8 data bits
• No Parity
2. RS-232 (9-pin d type connector)
Pin 2
RXD
Input
Receiving Data
Pin 3
TXD
Output
Transmission Data
Pin 5
GND
—
Signal Ground
9 Pin D Connector
Scale
Computer/Printer
Pin 2:
Pin 3
Pin 3:
Pin 2
Pin 5:
Pin 5
NOTE: If data is not getting in your computer/
printer, interchange pin 3 and pin 2 connections.
3. Continuously output protocol.
CONT: WEIGHING MODE
S
T
，
G S
k g CR LF
4. OD-2130D Printer Formats:
ENABLE WEIGHING UNITS
At startup, all weighing units are enabled – lb / oz / g / kg.
Enter this menu to change enabled weighing units.
NOTE: lb. weighing unit cannot be turned off.
1. Turn on the scale and press the
TARE
key
Tare
during
the self-test.
PO CAL
will be shown on the display.
PO CAL
2. Press the
TARE
key
Tare
until
P3 Unt
is shown on the
display.
3. Press the
ZERO
key
Zero
to enter the menu.
4.
kg
will be shown on the display. Press the
TARE
key
Tare
to select on or off. Press the
ZERO
key
Zero
to select
the new setting.
5.
g
will be shown on the display. Press the
TARE
key
Tare
to select on or off. Press the
ZERO
key
Zero
to select
the new setting.
6.
oz
will be shown on the display. Press the
TARE
key
Tare
to select on or off. Press the
ZERO
key
Zero
to select
the new setting.
7.
Press the
TARE
key
Tare
to view additional menus or
press the
MODE
key
Mode
to exit the setup menu.
OPERATION CONTINUED
