PAGE 2 OF 6
0521 IH-4440
ASSEMBLY CONTINUED
SPINNER BASE ASSEMBLY
1. Set spinner base top with underside facing up on a
protected surface.
2. Install camlock pins into predrilled holes of the spinner
base using screwdriver. (See Figure 1)
3. Set the kick base onto the spinner base so the
camlocks and camlock pins match up, and tighten
camlocks. (See Figure 5)
NOTE: If you do not want the spinner base to
rotate, install a screw through the bottom base
panel into the top base panel, taking care
not to puncture through the surface of the
top base panel. This will stabilize the spinner
component of the base unit.
CASTERS INSTALLATION (OPTIONAL)
1. Position the casters onto each of the four corners of
kick base assembly. (See Figure 6)
2. Using four pan head screws per caster, attach the
casters through the predrilled holes on the inside
corners of the kick base. (See Figure 6)
NOTE: Install all screws before the final
tightening to allow for easier alignment of
casters.
I-UNIT DISPLAY PANELS INSTALLATION
1. Flip spinner base top right side up.
2. Screw four camlock pins into the predrilled holes on
the top of the base.
3. Install the four camlocks into the two wing panels
using a rubber mallet.
4. Attach wings to center panel by installing confirmat
screws into predrilled holes using the Phillips
screwdriver. Be sure that the camlocks are facing the
center panel. (See Figure 7)
NOTE: Do not fully tighten screws until all the
panels are in place. Once wing panels are in
place, tighten screws completely.
5. Set the center panel and wing assembly onto the
base over the camlock pins and lock camlocks.
(See Figure 8)
6. To cover the exposed screw heads, peel the
decorative screw caps to expose the sticky back,
and carefully center and cover the screw heads.
Figure 5
Figure 6
Figure 7
Figure 8
Confirmat Screw
Wing Panel
Wing Panel
Center Panel
1-800-295-5510
uline.com
