0810 IH-2590
PAGE 3 OF 3
When problems occur, carry out the following procedures. If the tape dispenser does not operate normally after
following the troubleshooting procedures, contact your supplier.
WEEKLY
Wipe feed rollers and blade with proper solvent to
remove adhesive build-up.
MONTHLY
Apply silicone oil to #242 blade roller. Inspect pressure
rollers and cutting blade for wear.
TROUblESHOOTING
MAINTENANCE
OPERATING ISSUE
RECOMMENDATIONS
No power light / tape does not feed.
Unplug unit and plug in again.
Turn power switch off, wait 5 seconds, turn unit back on.
Check that front panel is closed securely, and safety
interlock is engaged.
Verify that the fuse has not blown.
Check that Tape Length Display is 40mm or greater.
Tape does not feed when unit is in
auto mode.
Check that Auto/Manual Switch is in correct position.
Turn Interval Knob all the way counterclockwise.
Wait 1 full second after tape is cut before removing
tape from machine.
Blade sticks in closed position
Apply silicon oil to #242 Blade Roller.
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA
