PAGE 2 OF 6
0421 IH-2051
OPERATION
RECORDING PUSH BUTTON CODES
INTO INDICATOR RECEIVER
NOTE: Power to indicator must be ON.
RECORDING PUSH BUTTON (+):
1. Press and hold Mode Switch #1 (See Figure 3) for
about 3 seconds. Release the switch when the
green LED at the top of the receiver starts blinking.
2. Press the (+) button on the Wireless Push Button
Remote. The green LED will turn off to show that the
code is recorded.
RECORDING PUSH BUTTON (–):
1. Press and hold Mode Switch #2 (See Figure 4) for
about 3 seconds. Release the switch when the
red LED on the Receiver starts blinking.
2. Press the (–) button on the Wireless Push Button
Remote. The red LED will turn off to show that the
code is recorded.
NOTE: A maximum of 15 codes can be
recorded per channel. To clear all codes, press
and hold Mode Switch #1 for about 3 seconds.
When the receiver’s green LED starts blinking,
release Mode Switch #1, then press and hold
it again for 3 seconds. Repeat the procedure
with Mode Switch #2. Range of operation is up
to 30m (100 ft) or more from indicator.
Mode
Switch
#1
Figure 3
Mode
Switch
#2
Figure 4
1-800-295-5510
uline.com
