PAGE 3 OF 12
0221 IH-1789
PANEL ASSEMBLY
INSTALLATION OF SELF-LEVELING FEET
1. Remove plastic top caps from all four posts. (See Figure 6)
2. Remove floor protectors and leveling bolts from metal inserts of
self-leveling feet located in post boxes. (See Figure 7)
3. Install metal inserts into holes where plastic top caps were. Make sure
insert is fully set into top of post. Tap into place with rubber mallet.
(See Figure 8)
ATTACH SIDE PANELS
NOTE: Do not screw in bolts until all panels are installed.
1. Assemble side panels with loops on top facing inward. Tilt panel so it
locks around posts on both ends, then slide down so loops are on top
of the metal insert that was installed at the top of the post.
(See Figure 9)
2. Repeat with second side panel.
ATTACH BACK PANELS
1. Assemble back left panel first. Place wires facing downward into
loops on side panel. (See Figure 10)
2. Repeat for the back right panel.
3. After all the loops are aligned on top of the metal inserts on the top of
the posts, screw in the bolt on all four posts and tighten using wrench.
(See Figure 11)
Top Cap
Figure 8
Figure 6
Figure 7
Figure 9
Figure 10
Wire
Loop
Metal
Insert
Figure 11
Metal
Insert
