PAGE 3 OF 12
0721 IH-1086
INSTALLING THE TIME RECORDER
UNPACKING AND INSPECTION
Carefully unpack your recorder and inspect it for any
damage. Verify that the following accessories are
included: three mounting screws, a case lock key and
the General Service Instructions. Report damage or
shortages to ULINE.
SITE REQUIREMENTS
The recorder should be mounted on a sturdy wall, shelf
or other support area. Do not use the recorder under
the following conditions:
• extremely high or low temperature
[operating range: 32° to 122° F (0° to 50° C)]
• extremely high or low humidity
[operating range: 0 to 90% RH non-condensing]
• areas of high dust concentration
• areas with extreme vibration or when placed on an
unstable or unlevel surface
MOUNTING THE RECORDER AND CARD RACKS
The recorder requires an uninterrupted AC power
supply and should be mounted within 6 feet of a power
receptacle to accommodate the unit’s power cord. The
suggested wall mounting layout for the recorder and
optional card racks is shown in Figure 4. Suggestions for
mounting on specific wall and shelf surfaces follow.
WOODEN/PLYWOOD WALLS
You may use the three screws included with the recorder
for mounting. Mark a location on the wall 53" above
the floor. Tighten a screw at this location, leaving about
1/8" protruding, and hang the recorder, fully tighten the
screw, and insert and tighten screws through the lower
left and right mounting holes. Use the same type of
fasteners to attach card racks.
MASONRY WALLS
You may use plastic masonry anchors and screws
available at your local hardware store to mount the
recorder. Mark a location on the wall 53" above the
floor. Drill a hole with a 1/4" masonry bit and insert a
plastic anchor. Tighten a screw at this location, leaving
about 1/8" protruding, and hang the recorder through
its "keyhole" on the screw. Level the recorder and mark
the location for the lower left and right mounting holes.
Remove the recorder, drill holes and insert anchors.
Replace the recorder, insert and tighten screws through
the lower left and right mounting holes and fully tighten
the "keyhole" screw. You may wish to attach plywood to
masonry walls to ease installation of multiple card racks.
SHEETROCK/HOLLOW CORE WALLS
You may use "molly" fasteners available at your local
hardware store to mount the recorder. Follow the
procedure for masonry walls, using the "molly" fasteners
instead. Alternatively, you may use longer wood screws
to attach the recorder to a stud behind the sheetrock,
using the "keyhole" and the lower center mounting
hole on the recorder. You may wish to attach plywood
to sheetrock walls to ease installation of multiple card
racks.
TABLE TOPS, BENCHES, AND SHELVES
You may use the two mounting holes in the bottom of
the recorder and the provided screws to secure it to
table tops, benches or shelves.
NOTE: Always consult with a professional
contractor/carpenter and obey all local
building and fire codes when installing your
recorder and card racks.
Figure 4 (suggested mounting layout)
32"
45"
RECEPTACLE
40"
