PAGE 2 OF 6
0323 IH-8945
ATTACH CASTERS
1. Lay tool cabinet on its back on a soft surface so the
bottom is accessible.
2. Align caster bolt holes with holes on the tool cabinet.
(See Figure 2)
NOTE: Install rigid casters on one end of tool
cabinet and swivel casters with brakes on the
opposite end.
3. Thread bolts with washers into holes using 12 mm or
13 mm wrench, but do not tighten completely.
NOTE: For H-8945 and H-8946: use 5/16 x 5/8
"
hex head bolts and lock washers with 12 mm
wrench.
For H-8947: use M8 x 25 hex head bolts and
washers with 13 mm wrench.
4. Repeat steps 2 and 3 for remaining casters.
5. Completely tighten all bolts.
DRAWER REMOVAL
1. Pull drawer out until fully extended. (See Figure 3)
2. Push down on black release lever on right side of
the drawer, while pulling up on the black release
lever on the left side.
3. While holding levers in the positions as illustrated, pull
drawer outward until it is released from the slides.
DRAWER REPLACEMENT
1. Extend the drawer slides from the cabinet.
2. Insert brackets on each side of drawer into the slots
in the slides, being careful to position them properly.
3. Once inserted, close the drawer completely to set
the slides in their proper positions.
Figure 2
ASSEMBLY CONTINUED
Figure 3
Push down the right side
Pull up left side
1-800-295-5510
uline.com
