PAGE 4 OF 5
0818 IH-2606
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are for maintenance-free
operation. However, on rare occasions the sensors may
become blocked by paper dust, causing the motor to
run even when there is no paper present.
NOTE: Two paper detection sensors are located
in the center of the paper entry.
79Ci
16
79Ci
1. Turn off and
unplug shredder.
2. Locate auto-start
infrared sensor.
3. Dip cotton swab
in rubbing alcohol.
4. Using cotton swab, wipe away any
contamination from the paper sensors.
MAINTENANCE
TROUBLESHOOTING
16
79Ci
1. Apply oil
across entry.
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and
could ultimately stop running. To avoid these problems,
we recommend oiling shredder each time user empties
waste bin.
CAUTION! Use only a non-aerosol vegetable oil
in long nozzle container, such as S-16094.
Follow oiling procedures below and repeat twice.
2. Press and hold forward ( )
for 2-3 seconds.
OPERATING ISSUE
RECOMMENDATIONS
Overheat Indicator
When the Overheat Indicator is illuminated:
1. Allow the shredder to cool down.
2. Resume shredding once the Overheat Indicator is no longer
illuminated.
Bin Open
When Bin Open is illuminated:
1. Close the bin.
2. Resume shredding.
Bin Full
When Bin Full is illuminated:
1. Empty the bin.
2. Resume shredding.
