PAGE 2 OF 5
0818 IH-2606
SAFETY
CASTER INSTALLATION
• Operation, maintenance and service requirements
are covered in these instructions. Read completely
before operating shredder.
• Keep away from children and pets. Keep hands
away from paper entry. Always set to OFF (O) or
unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters top
opening, switch to Reverse (
) to back out object.
• Do not use aerosol products, petroleum-based or
aerosol lubricants on or near shredder. Do not use
canned air or air dusters on shredder. Vapors from
propellants and petroleum-based lubricants may
combust, causing serious injury.
• Do not use if damaged or defective. Do not
disassemble shredder. Do not place near or over
heat source or water.
• This shredder has a disconnect power switch that must
be in the ON (I) position to operate the shredder. In
case of emergency, move switch to OFF (O) position.
This action will stop shredder immediately.
• Avoid touching exposed cutting blades under
shredder head.
• Shredder must be plugged into a properly
grounded wall outlet of the voltage and amperage
designated on the label. The grounded outlet or
socket must be installed near the equipment and
easily accessible. Energy converters, transformers or
extension cords should not be used with this product.
• Fire hazard – do not shred greeting cards with sound
chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
1. Locate casters.
2. Lay shredder
on its back.
3. Insert casters
into housing.
4. Flip upright.
79Ci
OPERATING INSTRUCTIONS
Continuous operation
up to 20-minute maximum.
NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation
beyond 20 minutes will trigger 30-minute cool down period.
16
79Ci
16
79Ci
16
79Ci
1. Plug in and
put disconnect
power switch in
ON (I) position.
2. Press ON ( )
to activate
(blue).
3. Feed paper
straight into
paper entry
and release.
4. To shred CDs
or credit cards,
rotate safety
flap into place.
5. Hold card/CD
at edge. Feed
into center
of entry and
release.
6. When finished
shredding,
set to OFF ( )
position.
