U-Line Corporation
P.O. Box 245040
•
Milwaukee, WI 53224-9540
Phone 414.354.0300
•
FAX 414.354.7905
www.u-line.com
Figure 3A
Top View of Door
Figure 3B
Back View of Door
Figure 3C
Bottom View of Door
Figure 3D
Side View of Door
3/4"
1/8"
1/8"
R1/32"
DOOR BOTTOM:
CHAMFER 1/32" X 45
°
5/16" Dia. X 1/4" DEEP
3/8"
13/32"
1/8"
1-17/32"
13/16"
7/16"
13/32"
13/16"
R1/8"
5/16" Dia. X 1/2" DEEP
0.177" Dia. (#16 DRILL)
X 11/16" DEEP
3/8"
13/32"
13/16"
2A. Route notch in top corner of panel as shown
(Figures 3A and 3D). Notch is entire depth of
panel, front to back.
Width: 13/16"
Depth: 1/8"
2B. Route notch in back side of top corner of panel
(Figures 3B and 3D).
Width: 13/16"
Depth: 1/8"
Height: 1-17/32" from top edge of panel (less
1/8" for depth of notch on top of panel)
Radius of corner notch: 1/8" (Figure 3B)
3.
Drill holes for pivot plate mounts (Figure 3B).
5/16" diameter x 1/2" deep, from the routed
surface
4.
Drill hole for upper door hinge (top of panel)
(Figure 3A).
0.177" diameter
(#16 drill) x 11/16" deep
5.
Drill hole for lower door hinge (Figure 3C).
5/16" diameter x 1/4" deep
NOTE
It is important to ensure that all drilled holes
are drilled to the correct depth in order to
avoid splits in the wood when hardware is
installed.
