PAGE 6 OF 24
0421 IH-7741
BACK-TO-BACK WORKSTATION ASSEMBLY
1. Place desk frames together. Align dual bracket
with holder with holes on top of support frames and
attach using four M6 x 15 mm bolts. Repeat for
remaining dual brackets with holder. Insert acrylic
panel into dual brackets with holder. Align dual
bracket with holes on top of leg frames and attach
using four M6 x 15 mm bolts. Repeat for remaining
dual brackets. (See Figure 13)
NOTE: Additional Back-to-Back sets can be
added to create longer configurations. To
extend workstation, attach dual brackets to
end of desks and connect additional sets
during this step.
2. Place tops over frames. Align holes on tops with
holes on frames and attach using M6 x 60 mm bolts.
(See Figure 14)
NOTE: Parts from page 1 will be used during this
step.
3. Align holes on modesty panel with holes on legs and
attach using four M6 x 15 mm bolts. Insert black or silver
grommets based on preference. (See Figure 15)
BACK-TO-BACK WORKSTATION PARTS LIST
Dual Bracket x 2
M6 x 15 mm Bolt x 16
Dual Bracket with Holder x 2
Acrylic Panel x 1
Figure 13
M6 x 15 mm
Bolt
Dual Bracket
Dual Bracket
with Holder
Figure 14
Figure 15
Modesty Panel
Attachment