PAGE 2 OF 24
0421 IH-7741
DESK AND TABLE ASSEMBLY CONTINUED
2. Insert adjustable glide into foot of each leg.
(See Figure 2)
• For Desk and Table assembly, proceed to
Step 3.
• For L-Desk and L-Desk Workstation assembly,
proceed to Step 1 on page 4.
• For Back-to-Back Workstation assembly,
proceed to Step 1 on page 6.
3. (Optional) If privacy panel was purchased, align
dual bracket with holes on top of support frame
and attach using two M6 x 15 mm bolts. Repeat
for remaining holes on same side of support frame.
Insert acrylic panel into dual brackets with holder.
(See Figure 3)
NOTE: If privacy panel is attached, keep frame
upright for Steps 4-5. (Optional privacy panel is
not shown.)
4. Place top on ground with underside facing up and
flip over assembled frame. Align holes on top with
holes on frame and attach using 10 M6 x 60 mm
bolts. (See Figure 4)
NOTE: For H-8948 and H-8999, attach top and
frame using eight M6 x 60 mm bolts.
5. If assembling a desk, align holes on modesty panel
with holes on legs and attach using four M6 x 12 mm
bolts. (See Figure 5) If assembling a table, apply
adhesive covers to holes on legs. (See Figure 6)
NOTE: Ensure desktop is attached before
attaching modesty panel.
Figure 2
Figure 3
M6 x 15 mm
Bolt
Allen
Wrench
Acrylic
Panel
Dual Bracket
with Holder
M6 x 12 mm
Bolt
Figure 5
Figure 4
M6 x 60 mm Bolt
Allen Wrench
Adjustable Glide