PAGE 4 OF 36
0521 IH-800
INSTALLING THE BOTTLE AND WATER TANK
1. Insert the brush assembly in the water tank. The
brush assembly must be tilted toward the dispenser
so that the cotter pin will clear the retaining bracket
as it is pressed into place. (See Figure 8) Then rotate
the brush forward so that it seats flatly on the bottom
of the water tank. The edge of the base of the brush
should be under the retaining bracket.
2. Lift the front of the heater assembly and slide the
water tank into position at the front of the dispenser.
NOTE: Brushes must be angled
toward the front of the dispenser in
order to work. Installing the brushes
backwards will cause tape to jam.
The bottom of the water tank should be even with the
edges of the shelf it sits on and the water tank will drop
slightly into the shelf when it is correctly positioned.
(See Figure 9)
3. Lower the heater assembly.
4. Fill the bottle with water.
NOTE: We recommend using Penetron® or a
similar wetting agent if you have hard water.
This will keep mineral deposits and bacteria
from building up in the brushes, bottle, and
water tank. These deposits can lead to poor
tape adhesion. Penetron® helps the water
more quickly penetrate into the adhesive for
better performance.
5. Position the bottle onto the right side of the
dispenser. The spring-loaded center of the bottle's
cap must be on the pylon protruding from the water
tank. (See Figure 10)
ATTACHING THE POWER CORD
1. Ensure that the power switch is in the OFF (down)
position. (See Figure 11)
SETUP INSTRUCTIONS CONTINUED
Retaining Bracket
Figure 8
0 12
3 4 2 12
3 561
3 7
85912
5
: ;
<7 =2 8
3
4 2
4 2
5
3 2 8
5
112 >6
< ?
@4 2
3 5:
A
=9
<<
;8
7 B
1
< 9C
4 3 < ?
9:
3 7
3 4 91
1
4 2
<D
=
4 2 :
9
3
91
E7 882 E3
< ?
B7
19
3 9
7
: 2
;
Figure 9
F G H
I G
J
KL
I M G
N K
I I O G
PQR
L S
I T
KU G J
I M G
R V
O K H
SH
I M G
I Q H
W
XKI I
O G
H KJY
QOO V
L S
I T
SH
I M ST
Q JG
Q
Figure 10
Figure 11
