©2006 U-Line Corporation
Publication No. 30138
04/2006 Rev. A
U-Line Corporation, located in Milwaukee, WI, is a family operated manufacturer of built-in
undercounter icemakers, Combo
®
icemaker/refrigerators, Wine Captain
®
wine storage units,
refrigerators, refrigerated drawers and refrigerator/freezers.
For more than four decades, U-Line has distinguished itself as the leader in built-in
undercounter ice making, refrigeration and wine storage appliances.
Assembling the Door
Starting at the corners and working toward the center,
push the door gasket back into place. Make sure gasket is
fully seated on all four sides.
NOTE:
Door hinges are attached to unit for right-hand
swing. Refer to your user manual for instructions to
reverse. (Be sure to also move the spacers with the
hinges.)
Installing the Door
IMPORTANT
Pivot posts must be clean. Closers must also be
clean and greased with petroleum jelly to ensure
proper operation.
1. Install one of the pivot posts (P/N 42096) into bottom
hinge (using Phillips screwdriver), making sure post is
seated fully.
2. Remove pre-greased closure assembly (male closer P/N
31672 and female closer P/N 31673) from poly bag (P/N
37015) and slide over bottom pivot post, making sure
that bosses align with holes in hinge and that assembly
is fully seated
(Figure 8)
.
3. Position door over door closer. Be sure the door hinge
plate holes align with the bosses on the closer
(Figure
8)
. Failure to do this will result in the door not aligning
properly.
4. Holding the door in the closed position, install the other
pivot post (P/N 42096) through the top hinge (using a
Phillips screwdriver) into the top pivot plate, making
sure post is seated fully.
5. Adjust door as needed for proper closure. Refer to user
manual for door adjustment procedures.
ULIN_0420_A
DOOR
CLOSER
INSERTS
BOSS
Figure 8