µ-Dimension BST 1200es, User Manual

Page: 20 / 74

20 Setup
Dimension BST 1200es / SST 1200es User Guide
Powering On Dimension
Dimension’s power switch is located on the front of the cabinet,
near the bottom right corner (see
Figure 6 ). After the switch is
pushed, Dimension boots up in three to seven minutes.
Figure 6: Location of Power Switch
(View From Front of Printer)
WARNING
Dimension’s build chamber and
extrusion-head tip get very hot! The
chamber and head tip reach
temperatures of approximately 75
°
C
(167
°
F) and 300
°
C (572
°
F) respectively.
Personal injury can occur if proper
techniques and safety materials are not
used. Use the leather safety gloves
provided in the Startup Kit when working
inside the printer.
CAUTION
Remove the foam tubes that isolate the
extrusion head from the frame (see
Figure 3 on page 17
). The printer will be
damaged if powered on with the foam
tubes in place.