![background image](http://html2.mh-extra.com/html/qms/magicolor-6100/magicolor-6100_supplementary-manual_3225297001.webp)
d
Make a note of the value (-4 to +4) associated with that
block, or simply mark the pane through the cutout in the
card.
You will need this value in step 6.
e
Repeat steps b–d with the magenta, yellow, and black
calibration cards.
5
Access the printer’s Administration/Engine/Density/Cyan
menu.
6
Adjust the cyan color density according to the number
you recorded in step 4.
Press the Previous key to decrease the density setting or the
Next key to increase the setting.
7
Repeat steps 5 and 6 for the magenta, yellow, and black
color densities.
8
Save your changes.
9
Print a new calibration page (Administration/Special
Pages/Calibration Page menu).
10 Compare the new calibration page to the four calibration
cards again.
11 Make any additional adjustments necessary.
If none are necessary, you’re done and ready to print.
®
®
QMS and
magicolor
are registered trademarks of QMS, Inc. All other trademarks
are the property of their respective owners.
Copyright © 1999 by QMS, Inc. All Rights Reserved.