u-blox XPLR-AOA-3, User Manual

Page: 7 / 44

UBX-22006906 - R03 Page 7 of 44
C1-Public
2.2 Assembling the kit
1. Connect to the ANT-B10 board to the EVB-ANT-1 board. Physically align the boards and gently
plug the 20-pin, male and female, header connectors together.
Figure 2 shows the location of the
header connectors on each board.
Figure 2: Assembled XPLR-AOA-3 kit showing EVB-ANT-1 and ANT-1 headers
2. Using the supplied standoffs and screws, assemble the two PCBs to the plexiglass, as shown in
Figure 3 . The assembly order of the components (see Kit includes ) are as follows:
a. Plexiglass
b. M3 30 mm standoff
c. EVB-ANT-1 PCB (Connector side up)
d. M3 8mm standoff
e. ANT-B10 PCB with connector side down, fix connectors
f. M3x6 screw
Figure 3: ANT-B10 and EVB-ANT-1 with plexiglass enclosure
☞
The plexiglass has a 3/8” UNC thread available in the middle of the panel. This can be used to
connect tripods or via an adapter set use ¼” camera clamps or tripods.
It can also be used to
mount the anchor node to a wall or ceiling.